Professional printing of ribbon rolls with the COLOP e-mark Ribbon Station

Assembly
First of all, the Ribbon Station has to be assembled:

1. Put the roll holder into the opening
2. Put the screws into the predrilled holes and fasten them
3. Put the pin into the roll holder

Station Preparation
Next the Ribbon Station has to be prepared for printing:

1. Choose the size of ribbon you want to print on (10, 15 or 25 mm) or one of the endless labels (15 mm)
2. Put the roll on the roll holder and adjust the pin to fix the roll into place
3. Put the appropriate Ribbon Guide (to fit with your ribbon size) into its predefined space
4. Thread the ribbon or endless label under the horizontal wooden sticks, around the vertical wooden stick and through the Ribbon Guide.

Caution: When using the endless labels make sure the underside is facing upwards when threaded through the wooden sticks and the side to be printed on is facing upwards when threaded through the Ribbon Guide.

Finally, send the Ribbon Station imprint to the e-mark, put it into place and pull on the ribbon or endless label. The imprint is printed onto the material as long or often as you have defined in the app.

The Ribbon Station makes it is possible for the first time, to print a whole roll of ribbon in just a few minutes, wherever and whenever you need it. These fully customisable ribbons are printed in full colour and in high quality. The option to choose which length of ribbon to print on, adds a new level of customisation.

The possibility to decide how often the imprint is printed onto the roll of material comes in especially handy with the COLOP e-mark endless label range.